The pulse OPs are for critical timing measurements.Īt present I intend for this data to be read by a logic analyser and that may be the only option short of also building a hardware debugging device but is there anything I could do to make it more Visual Micro friendly? I doubt it as I guess you really only have access to a serial/USB port but maybe there's something I haven't thought of. This is all memory mapped so in theory you could output a 32-bit variable in just a few nS with a single assignment using a pointer. Currently I have two pulse outputs and the ability to write eight bits to special header pins. Thank you so much.I'm designing a SAM3U board at present and am adding hardware to allow non-intrusive debugging for time-critical code. You are ready to write with the coolest autocomplete ever for your favorite Arduino board. Again, navigate to Tools -> Visual Micro -> Programmers and select Arduino as ISP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |